While the recommended Inateck cards indeed have only one USB controller, such a card will support up to two Oculus Sensors in USB3 mode just fine. There's a large amount of misinformation in this thread. No low effort submissions memes, gifs, image macros, etc.Read the FAQ before posting a question.This is a place for friendly VR discussion, so don’t start drama, attack, or bait other redditors.New Oculus owner? Thinking about buying one? Just have questions? Click here for the subreddit wiki! Rules of the Oculus Subreddit Then, windows 10 installs a 'USB Video Device' Microsoft driver, which also doesn't work.Welcome to /r/Oculus, a place for Oculus fans to discuss VR. I have also tried uninstalling and deleting their driver and then rebooting and attaching. The display is a Dell E2414H attached to the DVI port on the motherboard, and an identical monitor attached to the USV display adaptor via the VGA D-Sub.įresco Logic is useless, they say it should work. PC is an HP desktop with an AMD A8-6500 APU with Radeon HD graphics at 3.5 GHz, 8 gig of ran, and windows 10 is (as was 8 and 8.1) installed as a 64 bit operating system. My second monitor is attached via a Fresco Logic FL2000 USB 3.0 display adaptor.Īfter visiting their support page, I unplugged it, went into device manager, uninstalled it, deleted the directory, downloaded the latest driver per their instructions ( version 1.315.0), rebooted, installed that driver, rebooted, plugged the device in, The device is not compatible with this graphics card driver. Update went well, but second monitor is blank and on boot a notification is displayed: Updated windows 10 from 8.1 on 10 Sept 2015. Fresco Logic Fl2000 USB 3.0 Video display adaptor will not work after windows 10 update

Fresco logic usb driver